- ホーム
- > 洋書
- > 英文書
- > Science / Mathematics
Full Description
Volume is indexed by Thomson Reuters BCI (WoS).
The literature detailing the effects of varying operating parameters on tool life when machining Titanium alloy is comprehensive, however, relatively little of this data refers to their effects on machined workpiece surface integrity particularly, residual stress generation and distortion created. Greater knowledge of the effects of operating parameters on surface integrity is critical to the acceptance of new environment, cutting path and cutting sequence strategies on machining of Ti6Al4V aerospace alloys to increase the functional requirements and fatigue life of the milled thin components. In this book four chapters have been included to address the above reported issues.
Contents
Preface
Turning Investigations on Machining of Ti64 Alloy with Different Cutting Tool Inserts
Multi-Objective Optimization on Drilling of Titanium Alloy (Ti6Al4V)
Experimental Study on Tool Wear when Machining Super Titanium Alloys: Ti6Al4V and Ti-555
Statistical Approach for Modeling Abrasive Tool Wear and Experimental Validation when Turning the Difficult to Cut Titanium Alloys Ti6Al4V
Laser Assisted Machining of Titanium Alloys
Influence of Tool Geometry and Machining Parameters on the Surface Quality and the Effect of Surface Quality on Compressive Strength of Carbon Fibre Reinforced Plastic
Analysis of Stresses in CFRP Composite Plates Drilled with Conventional and Abrasive Water Jet Machining
Challenges in Drilling of Multi-Materials
