- ホーム
- > 洋書
- > 英文書
- > Science / Mathematics
Full Description
This special edition presents recent advances in the analysis of heat and mass transfer phenomena, performance, and structural transformation of engineering materials under complex operating conditions.
Contents
Preface
Chapter 1: Numerical Investigation of Heat and Mass Transfer Processes
Numerical Study of MHD Natural Convection in Partially Heated Cubical Cavity Filled with Hybrid Nanofluid
Rarefied Gas Flow in a Micro Cavity with an Inner Obstacle Using the Lattice Boltzmann Method
Validation of Lattice Boltzmann Method in Two and Three Dimensions
Lattice Boltzmann Simulation for Combined Natural and Forced Convection in a Lid-Driven Square Enclosure with an Inner Heat Sink
Simulation of Natural Convection in a Triangular Cavity Using the Multi-Relaxation Time Lattice Boltzmann Method: Impact of Heated Chip Position
Chapter 2: Corrosion and Tribological Properties of Structural Materials
Corrosion Durability of the Deposited Layer on the Thin-Walled Base of Structural Elements Produced by Laser Radiation
Investigation of Stress Concentrators in Welds on Stress-Corrosion Cracking of X70 Steel Welded Joints in Near-Neutral pH Solution
Influence of Chemical Carbon Microheterogeneity on Fatigue Crack Growth Parameters in Railway Wheel Steel
Improvement of Tribological Properties of Steel by Femtosecond Laser-Inductive Microstructuring
Wear Behavior of Detonation-Sprayed (Ti,Cr)C-Ni Coatings under Dry and Lubricating Environment
Chapter 3: Microstructure Evolution in Advanced Materials
Enhancement of Mechanical Properties in Al0.35CoCrFeNi Complex Concentrated Alloys Through Grain Size Tailoring
Influence of Growth Rate on the Microstructure and Properties of EuBCO Bulk Superconductors Prepared by Top Seeded Melt Growth Process
Comparison of Properties of CeO2 Doped ZrO2 Samples Prepared by Conventional Sintering and by SPS
The Influence of the Final Machining Process on the Change of the Microstructure in the Surface Region of Austenitic Stainless Steels
Microstructure and Hardness Distribution of Laser Powder Bed Fusion-Produced AISI 2507 Super Duplex Stainless Steel
